Understanding the LED of Iotplus MoWi Wi-Fi sensors
This article will help you understand the behavior of the LED light on Iotplus Wi-Fi sensors (MOWI Sensors) in different scenarios.
When Batteries are Inserted
As soon as you insert the batteries there are a few possible scenarios that could happen, but the LEDs will let you know exactly what is happening.
- One RED flash
If this happens it means that the sensor cannot connect to a Wi-Fi network. This is caused by one of the following:
- No network security has been stored in the sensor.
- There is no open (unsecured) Wi-Fi network.
- The programmed Wi-Fi network cannot be found.
- Two slow RED flashes
If you see this it means that batteries are too low for the sensor to operate. New batteries are needed.
- GREEN flashes
If you see this, it means that the sensor has found a Wi-Fi network and is authorizing network credentials.
- GREEN flashes – End on GREEN
When this happens, it means that the sensor has successfully connected to the Wi-Fi network.
- GREEN flashes – End on RED
If you see this, it means that the sensor was not able to complete the authorization. Either the network SSID or security key does not match, or there was some other communication problem.
- 20 second Red Flash
If you see this, your sensor may not be able to communicate with your PC. In this case, the sensor may need to be sent to Iotplus for repair.
When Tethered to a Computer via USB Programming Cable
When first tethered to the computer the following LED light sequence should be expected: RED, GREEN, OFF, RED, GREEN, OFF.
Once the computer acknowledges the connection, the light should just flash GREEN.
Once the sensor is disconnected from the computer the sensor will try to connect to the Wi-Fi network. You will you see one of the following LED behaviors:
- It flashes GREEN and ends on GREEN.
This means it was connected successfully.
- It flashes GREEN but ends on RED.
If this happens reconnect the sensor to the computer and verify the network SSID and security key are correct.
During Sensor Operation:
Once the sensor has been set up and operating normally, in order to save battery, the light will not flash.
If you would like to enable the LED for normal operation (visual confirmation of communication). You can do this from the Iotplus Online Portal. When enabled the LED will flash indicating that network communication is occurring and sensor data is being delivered to the online system.